![]() |
![]() |
![]() |
This is an attempt to make the landing gear |
It's made from reinforced mat board |
![]() |
![]() |
The steps have been added |
? |
![]() |
![]() |
Foot pad underway |
Almost ready to be cast in resin |
![]() |
![]() |
Rubber mold made |
Resin casting |
![]() |
![]() |
Hinge pin on lower step |
Connected to strut |
![]() |
![]() |
One landing gear hole cut out |
Fitting landing gear |
![]() |
![]() |
Gear well and steps |
Foot pad sliding door |
![]() |
![]() |
Three stages of closure |
Hinges on top of steps |
![]() |
![]() |
Installed |
As this is not motorized there's a small pin hole to open and close the pad door using a paper clip |
![]() |
![]() |
There's only ... |
... two left to make |
![]() |
![]() |
The parts are redied for the next two pieces |
The doors for the upper landing gear well |
![]() |
![]() |
The piece of string in the photo above this was used to make the pseudo spring above the foot pad |
Thanks to a 60 degree day in January I got four landing gear well pieces primed |